Princeton Reverb Footswitch Help

[Jiverson]

Hey dudes and lady dudes:

I have (what I hope) is an easy one for you guys. I need a new footswitch for my Princeton Reverb. Original one has a mind of its own sometimes. So after completing a couple Madbean pedals, I thought "Oh, I'll just make myself a nice one with a detachable cable and LEDs and it'll be a breeze..."

Problem is, I can't find a good diagram that fits my needs anywhere. Googled for over an hour and so I thought I'd turn to the experts.

I have:
• 2 3PDT switches left over and thought I could just use those instead of ordering more stuff (even though it's probably excessive for this.)
• 2 LEDs
• 1 stereo jack
• 2 resistors (4.7k, again, leftovers)
• battery snap

Possible with what I have on hand??

If anybody can sketch this diagram up quick, it would be much appreciated. And, if it helps in your decision to help out at all...It's my birthday.

Sorry this isn't Madbean product specific, but I assume this will be a great little project for beginner's like myself and would be good to document. Thanks for reading.
-Josh