Grapevine rock/rawk switch wiring

[atreidesheir]

I am finally building my grapevine I purchased 18 mos ago.

I want to wire the rock/rawk switch 3pdt switch and I am not skilled enough to lay it out.
I have read posts from other members about this, but I have searched and cannot find a wiring diagram for the footswitch.
Can anyone please show me how to wire the switch?
thanks.  I hate to ask for stuff, but I am trying to do this the correct way.

[atreidesheir]

If I exclude C6, C7, and C8, and R7 and R8, would I need a jumper on the switching pads to just exclude the switch altogether and have just the Rock mode.  I do not care much for toggle switches.   

[atreidesheir]

Should I post this in the tech help forum?

[jkokura]

I'm confused with what you're asking for. Perhaps you simply need to clarify. The wiring diagram for the switch is in the build documents. As for removing a mode, I'd have to double check the schematic.

Jacob

[atreidesheir]

Thanks,
I mean to remove the Rawk mode.

[jkokura]

What I recommend you do is to fill in all the parts, then pick the mode you want to play through and use jumpers to make it permanent.

Jacob