No battery snap & switch wiring question

[theviper21]

If I want to omit the battery snap and just use the D/C adapter, do I just run a wire from the input ring to the dc jack or do I just forget the wires between the snap and the swith/dc jack?

Also, for the 3PDT footswitch, there are three different places you connect the ground. For the actual wiring, is it best to just run small jumper wires between the three connections? I haven't been able to find any up close pictures of what it's supposed to actually look like.

Thanks!!

[sgmezei]

Just leave the battery snap unconnected at both connections. Thats it! easy hey?

Now for the stomp switch. I use a leftover resistor lead that has been snipped to connect those three ground points but you can most certainly use a a bare wire. In fact, thats how I started doing it.

[theviper21]

Just leave the battery snap unconnected at both connections. Thats it! easy hey?

Now for the stomp switch. I use a leftover resistor lead that has been snipped to connect those three ground points but you can most certainly use a a bare wire. In fact, thats how I started doing it.

Brilliant idea on the switch, wish I would have saved my clipped leads!

[TNblueshawk]

Viper, thought I'd add if using the stereo input jack you never put anything on the ring lug. Also, since you are not using a battery you actually don't need to use a stereo input jack, you can use a mono there as well, like your output jack.