Up Down Daddy - Delykpcb

[Vivek_rc]

Hi All,

Just wanted to share my build of the up down daddy pedal from Delykpcb. It was a very challenging build and I'm very grateful it worked first time. I used 1/8 W resistors but still had to stand them up. The pedal sounds great and octaves track very well.

[jimilee]

Great pedal. It's nice to someone else build one too.


Sent from my iPhone using Tapatalk

[Vivek_rc]

Great pedal. It's nice to someone else build one too.


Sent from my iPhone using Tapatalk

Thanks Jimi, I saw you post on this pedal as well during my build, the pictures helped me with ensuring the components were the right way around!

[Thewintersoldier]

That is a tight build, looks way harder than the Madbean lowrider I did. Great Job!

[cooder]

Great build! So is this the small as 125B version of Lowrider with chips on both sides or what is it derived from?

[Thewintersoldier]

Great build! So is this the small as 125B version of Lowrider with chips on both sides or what is it derived from?

I believe the Pearl Octaver that the lowrider is based on but I wanna say its a 1590b!

[m-Kresol]

nice one! surely not an easy pedal to build!

[Vivek_rc]

I can say it was an easy build because it fired up the first time! I would hate to have had to troubleshoot this guy, it's right and complicated. I had some issues post build where the sound was cutting out and intermittent, I had a lucky guess and swapped out the two germanium diodes, some dodgy D9e I had, and replaced with BAT46 diodes. Now it's working well and no issues, just an FYI for anyone who attempts this build. This fits into a 1590B but I had this trapezium shaped enclosure, a bit more room on top.