Can someone check my block diagram (parallel mixer - JMK paralyzer content)

[LaceSensor]

cool thanks very much for checking that for me

I beleive the RAT and lovetone big cheese are also in phase so hoping those will be fine

[diablochris6]

I made a PCB for this situation a while back!
https://www.madbeanpedals.com/forum/index.php?topic=23321.msg228630#msg228630

[LaceSensor]

I made a PCB for this situation a while back!
https://www.madbeanpedals.com/forum/index.php?topic=23321.msg228630#msg228630

awesome
you need to make it available, id buy a couple

[LaceSensor]

Hey Guys

So I finished this build, and its actually amazing.

On testing I have figured out the following options with the Paralyzer from JMK:

Send one goes to a Rubadub Reverb into a RAT, which you can turn them off independently with their own switches.
The other send goes to a Big Cheese, again on a toggle switch.
Both paths are them "summed" at the output jack.

1 - Reverb.
2 - Reverb into RAT.
3 - Reverb into RAT with clean blend (Cheese toggle off).
4 - RAT only
5 - RAT with clean blend (Cheese toggle off)
6 - Big Cheese only
7 - Big Cheese with clean blend (RAT and Reverb toggles off)
8 - RAT and Big Cheese in parallel
9 - Reverb into RAT with Big Cheese in parallel
10 - Reverb with Big Cheese in parallel
11 - Reverb with clean blend (bear in mind the Reverb knob itself is a type of clean blend)
12 - Clean with clean blend 🙂 🙂 AKA the pedal does nothing sound

Thanks for all the advice and comments, it helped with pulling this off.