PCB Layout Check

[skypn]

Please tell me if you have any issues with my layout. TIA

[matmosphere]

I believe you have something going on with the IC being flipped.

For example in the schematic the 9v connects to pin six. on your layout it is connected to pin 3

[Caedarn]

The IC on the layout looks 'mirrored' - like the view is from the bottom rather the top of the IC. I think the connections look right based on the location of Pin 1.

[skypn]

Thank you both for your replies.
JoeR, you are correct. The view shown is looking at the solder side.

[m-Kresol]

I think the 220uF output cap is pretty big. usually we talk about nF for guitar and maybe 1 uF for bass or so, if I'm not mistaken.

did you build it and there's a problem or did you want to make sure before commiting?

[skypn]

I have bread boarded it, and it sounds fine to me. I just didn't want to waste an etched PCB that was laid out wrong.

[matmosphere]

The IC on the layout looks 'mirrored' - like the view is from the bottom rather the top of the IC. I think the connections look right based on the location of Pin 1.

Ahh, I apologize I was not looking close enough.