Tenebrion reverb in a 1590a

[Thomas3D]

Modified enclosure by drilling out one of the corner mounts. Lots of planning to get this in there and working. 1/8 watt resistors and low profile electros made it possible  https://imgur.com/gallery/oAAZn

[fair.child]

Wow... really hardcore. I bet it's a really tight fit and you get to lift the screws.

[Thomas3D]

Wow... really hardcore. I bet it's a really tight fit and you get to lift the screws.

The boards were dremeled down to fit within the lip of the bottom plate. Just enough room so that it screws down tight with no issue. I insulated the entire bottom of the board with wide electric tape.

Sent from my SM-G950U using Tapatalk

[Thomas3D]

Modified enclosure by drilling out one of the corner mounts. Lots of planning to get this in there and working. 1/8 watt resistors and low profile electros made it possibleTenebrion reverb in a 1590a  https://imgur.com/gallery/oAAZn

Forgot to mention,  16mm pots, they have smaller height than the 9mm.

Sent from my SM-G950U using Tapatalk

[alanp]

Super, super impressive.

[mrclean77]

Please remember that somebody, somewhere loves you, cares for you and doesn't want you to torture yourself this way!

Seriously, that's way up there on the 1590A 'no way they fit that in there' list. Nice work!!!

[287m]

WOW! great job!

i love the double sided green perf, cause i use that
but, i dont know what you use, single sided and two tone color? Green solder side and brown componen side?
where i can buy that?

[thomasha]

Wow a whole brick in a 1590a!
Cool build!

[Aleph Null]

I was expecting SMD. This is bananas!

[Thomas3D]

WOW! great job!

i love the double sided green perf, cause i use that
but, i dont know what you use, single sided and two tone color? Green solder side and brown componen side?
where i can buy that?

It's single sided, but masked, i just used the clad side for mounting and connecting the brick and the pots.