Demo Tape Fuzz

[culturejam]

Damn! That's a heck of a design/build. 

I remember boxes of BASF brand cassette tapes in Dad's old hi-fi cabinet.

I remember the BASF brand floppy disks I used with my Commodore 64 as a kid.

[Stomptown]

on a side note: do you think one could manage to put in top mounted jacks with 2 pots?

It's might work with 9mm pots and lumber jacks but I'm not totally sure.  There's not a whole lot of room up there!

[alanp]

CJ, did you cut notches in them, so you could use the other side too?

[intrentnet7]

That is a really impressive build.

Is that some kind of epoxy or glaze you used to coat the artwork like a Parks super glaze or envirotex?

[Stomptown]

That is a really impressive build.

Is that some kind of epoxy or glaze you used to coat the artwork like a Parks super glaze or envirotex?

Yep.  It's envirotex.  Pretty easy to work with after a bit of trial and error.

[stringsthings]

Super nice build!

[intrentnet7]

Yep.  It's envirotex.  Pretty easy to work with after a bit of trial and error.

Nice! I'll have to give a try.



Sent from my iPhone using Tapatalk

[jprizz]

That is a stellar build, top notch!

This is the comment of the year though. You sir win the all the internets

Those are like the orthopedic shoe of knobs and you even managed to make them look perfect.

[lego4040]

WOW, beautiful all around. I thought about picking a couple of those encloses. Creative decal skills

[AntKnee]

Classy.
Clean.
Great work.

[selfdestroyer]

Man, look at that rib cage!

Looks awesome Jon.

Cody

[Aleph Null]

Those are like the orthopedic shoe of knobs and you even managed to make them look perfect.

I have high arches! I need the extra support when turning knobs with my toes!

Seriously, though; that is a spectacular build. Graphics are understated and elegant. Guts are super clean.

[reddesert]

So very sweet, both graphics and build.

I can't get over how beautifully symmetric the jumpers are. Did you have jigs for bending and assembly? If I tried to do that, they would each be bent differently, get crooked when soldering in, and have scratches/pliers marks from the shaping.

[Stomptown]

So very sweet, both graphics and build.

I can't get over how beautifully symmetric the jumpers are. Did you have jigs for bending and assembly? If I tried to do that, they would each be bent differently, get crooked when soldering in, and have scratches/pliers marks from the shaping.

I basically stretched a long piece of bus wire, cut it into pieces, bent them across the thin side of a board, and inserted them one by one.  Finding a board of the right thickness was the key.  Other than that it was pretty easy.

[alanp]

You're more patient than me -- I would have just stuffed a load of zero-ohm resistors in there!