Serendipity / ZenDrive Voice Pot Question

[Micpoc]

As I have consistently since I built my first pedal in 1999, I made a mistake in my Mouser order for a Zendrive build: I neglected to order a 10kB pot for the voice control.  It does not matter how many times I go over the BOM and the shopping cart; a mistake nearly always occurs, and it is always MY fault.  

I DO have some 5kB pots AND some 25kB pots. Would one of these be appropriate to use in place of the 10kB pot?

[thesmokingman]

5k is actually probably more reasonable for the voice pot than the 10K.

[Boba7]

Or use a 25k with a 15/18k in parallel?

[Micpoc]

5k is actually probably more reasonable for the voice pot than the 10K.

Good to know; thanks.

Or use a 25k with a 15/18k in parallel?

I always forget about parallel resistors... thanks for the reminder.

[midwayfair]

if you have a 10kA use that and wire it backwards. It will be better than any value of B taper. Otherwise, use the 5k. The 26k won't do anything for almost the entire travel.

[Micpoc]

if you have a 10kA use that and wire it backwards. It will be better than any value of B taper. Otherwise, use the 5k. The 26k won't do anything for almost the entire travel.

No 10kA pot. 

Do you not think the parallel resistor will work well with the 25kB?