lifted a couple pads on my current lover

[knifedawg]

hey y'all,

I totally messed up and lifted both pads on c14 on my current lover. I'm not very good at reading schematics so if someone could show me where to put this capacitor in the circuit, I'd be really appreciative.

thanks!

[zombie_rock123]

If its the current current lover (hah) i think youd be fine soldering the 100pf to lugs 1& 3 of the volume pot. Possibly.

[selfdestroyer]

hey y'all,

I totally messed up and lifted both pads on c14 on my current lover. I'm not very good at reading schematics so if someone could show me where to put this capacitor in the circuit, I'd be really appreciative.

thanks!

Just locate C14 on the schematic and see what parts connect to each side of C14 and just run jumpers.



If you look at the schematic above you could tie the cap to pin 2 and 1 of IC7.

Cody

[selfdestroyer]

If its the current current lover (hah) i think youd be fine soldering the 100pf to lugs 1& 3 of the volume pot. Possibly.

That would be easier than the IC pins.

[knifedawg]

thanks!