Shred Dominator

[chuckbuick]

It's been a while since I've finished a build.  And it feels great!  This is a GCFX Shred Dominator PCB designed by Yours truly.  The plan with this PCB design was to make it fit in a 1590B with top-mounted or side-mounted jacks.  Rej built his proto with side-mount and I'm happy to say the top-mounts just fit.  The new GCFX Helvete (HM-2) PCB uses the same footprint and control locations as this one so it will go either way as well.  I'm hoping to get my Helvete finished tomorrow.

*** NOTE - The 1590B drill template in the build docs are for side-mount jacks.  I'll get info for top-mounted jacks soon. ***

Thanks again to all who participated in the Metulz Trio group buy.  If you missed out and would like a PCB head on over to Grind Customs FX website and pick yourself up one there.

[GrindCustoms]

Dude! That's looking great, nice job on the top mounted jack 1590B... ...i say mission acomplished! 

[m-Kresol]

Damn that's hot

[wgc]

So awesome!

[selfdestroyer]

So clean! That decal came out great.

Can't wait to get my hands on them.

Cody

[jimilee]

Very cool


Sent from my iPhone using Tapatalk

[Martan]

Man that looks awesome! Your pics always look pro as well. Great work! I hope your pick hand can keep up with the urge to put it through the paces😀

[chuckbuick]

Thanks guys.

I hope your pick hand can keep up with the urge to put it through the paces😀

Not at all.  The pedal is a lot faster than I am

[Lubdar]

Looks Awesome!!!
Is it weird that for some reason I'm floored by the solder work on the pot lugs?

[wgc]

indeed, those are some fine looking solder joints, especially for that ancient thru hole technology you see in egyptian tombs from time to time. 

Only thing keeping this from meeting mil-spec is the wire strip lengths and the bare wire at the bypass.

[Martan]

Are you cleaning the flux off after? If so, what do you use?

[chuckbuick]

Looks Awesome!!!
Is it weird that for some reason I'm floored by the solder work on the pot lugs?

Thanks.  Might be a little weird but I'm not judging.

Are you cleaning the flux off after? If so, what do you use?

Yes.  Just using alcohol.  I prefer the 99% stuff but even 70% works.  Just takes a bit more time and more applications.

[TNblueshawk]

Great looking build Mark. Too clean in and out.

[Adam_DIY]

Wow that looks magnificent the decal is rodiculous.  Love it.

[chuckbuick]

Thanks again for the kind words, guys.

I added a note in my OP as well as the group buy thread that the 1590B drill template in the build docs is for side-mount jacks.  I'll get the info needed for top-mounted jacks soon.