Zero Point Micro into Smoothie - can you phase just the repeats?

[timbo_93631]

Pad 3 of the mix pot pads on the PCB to panner input and panner output to lug 3 of the mix pot.

[mcallisterra]

Pad 3 of the mix pot pads on the PCB to panner input and panner output to lug 3 of the mix pot.

Excellent. Thanks so much for all your help!

[mcallisterra]

I thought of another question about this idea:

Would the output from the JMK panner, being fed from the Mix pot, send out *only* the wet signal, i.e. not the very first note played? Ideally, in a two amp setup, I'd like to hear the first note only in the first amp, and then the second amp 'come alive' with the first repeat, if that makes sense.

[kothoma]

The played note IS the dry signal, isn't it?
The wet signal (at the mix pot) has delayed notes only.

[mcallisterra]

The played note IS the dry signal, isn't it?
The wet signal (at the mix pot) has delayed notes only.

That's what I figured, just wanted to double check with you more knowledgeable folk. Thanks! 

[kothoma]

Good luck and keep us posted on your progress!

[mcallisterra]

you can just use the panner send as a line out, where it would just be a splitter.  If you have the blend control past noon on the loop side then you will have a reduction in volume of the repeats.

So I'm getting ready to do this build and have another question about the above: Wouldn't the 'blend' pot of the JMK Panner and the Mix pot of the delay essentially be doing the same thing - adjusting the volume of the repeats? If that's the case, is there a way to just fix the volume of the Panner so that only the Mix pot of the delay controls that? Or am I looking at this all wrong?

Thanks!