News:

Forum may be experiencing issues.

Main Menu

Neutrino (Burst)

Started by tenwatt, April 21, 2011, 01:23:10 PM

Previous topic - Next topic

bigmufffuzzwizz

Great update. It looks truely fantastic!
Owner and operator of Magic Pedals

mjcyates


azrael

So you clearcoated over the photo paper?
Any color bleeds?
Did you bake it to cure the clearcoat?

tenwatt

#18
Quote from: azrael on May 01, 2011, 03:25:25 PM
So you clearcoated over the photo paper?
Yes.  I used this paper (film).

Quote from: azrael on May 01, 2011, 03:25:25 PMAny color bleeds?
No.  The film I used has a special coating that kept it from bleeding.  It seemed to be ready to handle immediately after it printed and I stuck it and coated it within about 10 minutes of printing.  After peeling the backing off and sticking it to the enclosure I used the backing to lay over the art (smooth side down, against the art) while I rubbed it on with the smooth, round end of a Sharpie.  It didn't smear as I did this and it didn't bleed when I clear coated it.

Quote from: azrael on May 01, 2011, 03:25:25 PMDid you bake it to cure the clearcoat?
No.  I used Rustoleum and it's hard as a rock after a couple coats and you can't even see the edge of the film.  It almost looks screen printed on the enclosure.
Not too bright....

azrael

Wow, I just bought some Papillio adhesive paper and vinyl, but I may stop by Walmart too to get some of this.

Good to know that Rustoleum worked well, I'm using that right now, too! :D

PaxWorks

That is some awesome artwork! Great Job!

tenwatt

Quote from: PaxWorks on May 04, 2011, 05:36:58 PM
That is some awesome artwork! Great Job!
Thank you, sir.
Not too bright....

juansolo

Gnomepage - DIY effects library & stuff in the Stompage bit
"I excite very large doom for days" - playpunk

bangerang101

I love the artwork...awesome job on the wiring, and building as well... I'll have to try out that inkjet film stuff, seems like it's easy to work w/.... Great job!
Owner of Luck Duck Pedals (LDP)