Problem Yellow Shark PCB

[memor82]

Hi!
I've just got a problem with a Yellow Shark.
All pcb's holes was been hard to solder and a piece of link just jump of the board 
What can I do?
Thank you

[memor82]

Anyone?

Inviato dal mio Galaxy Nexus utilizzando Tapatalk

[muddyfox]

It's weekend man, patience! 

So, from what I gather, you lost the connection between round (cathode) LED pad and switch wire?

[memor82]

Sorry :-)
This is the single sided version.
I lost Sw and catode (circle)led pad
Thank you

Inviato dal mio Galaxy Nexus utilizzando Tapatalk

[muddyfox]

Run a wire from square LED pad to offboard LED anode and another wire from LED cathode to switch, that's all.

[memor82]

Ok I'll try!
Thank you so much.
Good weekend man

Inviato dal mio Galaxy Nexus utilizzando Tapatalk

[muddyfox]

That's gonna work for sure, what you lost does nothing more than give you nice labeled pads. It's a connection from LED cathode to wire which you can skip altogether since the LED is offboard anyways.

[memor82]

understood.there's always something to learn :-)
Thank you man

Inviato dal mio Galaxy Nexus utilizzando Tapatalk

[muddyfox]

No problem! Let us know when you sort it out!

[memor82]

Sorry man,
but I think that this pcb is faulty.
Now has jump off the "out" pad 
They letterally came off from the pcb

[muddyfox]

No problem, just solder it anywhere on the track leading from the missing pad. Hole is not really necessary if the wires are not under stress.

[memor82]

Ok thanks!

Inviato dal mio Galaxy Nexus utilizzando Tapatalk

[wgc]

Your iron might be too hot, also try to make the time you're on a pad with your iron less than 6 sec

[irmcdermott]

I agree that your iron may  be too hot if you are lifting traces and pads that easily/quickly.

[memor82]

I agree that your iron may  be too hot if you are lifting traces and pads that easily/quickly.

310 °c, few seconds
Already assembled Pork Barrel and a Retrograde and many other pedals from musikding and tagboard with no problem.
60/40 Solder