Mudbunny to Cornish G2

[neve1272]

ok i have a mudbunny board all socketed  spent this morning populating and this works. u used 1n270 diodes( i used bat 41 in my darkside build)

i did a pharoah tone stack and i gotta say sounds pretty good

used 100k pot for sus and vol also did not add the extra output resistors that are in the darkside schematic
   i just wanted to see if it would be close

[GVC66]

Wow, this thread took off like crazy...  Well, while I was away,  I tried several trannies and settled on bc550s ( I actually think guitarmaggedon suggested theses too ).  Used 103 for coupling, 1n60p for diodes, and after some serious swapping on the input cap I settled on 683.  I have not boxed it yet so I do not have a good way to compare to my dry (my test box is uber basic) but, I love this thing.  I was going to surround it with a couple of Cornishish buffers but I am not sure it is necessary.  I loved the demos out ere of the G2 and with this experimentation I think I have the spirit of it in a 1590b now.  Very happy.

[neve1272]

you have to put those extra component's on that last q4 (i attached at the junction of  R23 on new black mudbunny)
it will make the increase gain/output volume 

all said and done it is some what different then my darkside i dont know if the buffer  changes how hard the trannies get hit or if the diode are clipping different
still nice sounding muff