First gen Mystickal Unicorn pcb ?'s

[hogan]

Do I have to populate the portion of the board that was reserved for different clipping options?  Do I need to bare wire jumper anything.   Please advise.  Thanks in advance.

[madbean]

Here's the build notes on the MU that tells you how to do the stock clipping. Be sure to follow the component list for rev.1 of the board: there were a few value changes.

Attached.



[attachment deleted by admin]

[hogan]

on the dual gang gain pot, which set of lugs is "gain 1" and which is "gain 2"  when looking at the back of the pot?  Thanks.

[madbean]

It doesn't matter, but the easiest way on this layout is to have Gain1 go to the top row.

[hogan]

cool. Thanks.

[hogan]

What will happen if i wire in an on/on switch instead of a an on/off/on switch?  Is there anyway to have it stock and just the other set of clippers w/o the raw unclipped choice?

[hogan]

bump

[madbean]

On/On will work fine. Wire it the same way. The two positions of the switch will connect the different diodes to ground and produce the clipping. With on/off/on it doesn't connect the diodes in the middle position.