News:

Forum may be experiencing issues.

Main Menu

Double Flush Rate LED

Started by pjpedals, September 19, 2018, 06:30:10 PM

Previous topic - Next topic

pjpedals

Hi all, anyone find the value on the LED resistor going to the rate LED leaves the blinking indicator WAY too bright? I presumed I could just increase the value of r11 (this is on the single side etch layout), but I'm thinking that might interact with the values going to the LED/LDR combo and perhaps change the sound. I don't want to do that. Any thoughts?

pjpedals

Also, my depth pot isn't doing anything, the effect stays at max depth. I am now wondering if LDR/LED combo isn't getting bright enough, so maybe tweaking that whole voltage divider is in order for my specific combo? I'm using a yellow clear in the LED/LDR combo and a blue clear for the rate indicator.