Extra + and - pads on SAWSE board

[Guybrush]

Hi all

It's been a long tome since I put a Madbean board together and have seeminly forgotten some of the basics.

The SAWSE board has the usual four 3pdt connection pads at the base of the circuit: In, Out, 9vt and Grnd

At the top of the board are extra pads for 9vt and Grnd.

My question is do I need to connect these two extra pads to my test rig when testing the board or do I just need to connect the four 'normal' pads?

Thanks in advance

[WormBoy]

If I look in the build doc, there is no +9V connection at the lower end of the PCB: it's ground, LED switch ground, LED+, LED-, in and out. Makes sense as the switch does not need 9V  . The bottom ground pad is connected to the top ground pad (you can check with a DMM set for continuity). So, the top 9V+ goes to your testing rig, either of the grounds, and the in/out.

[Guybrush]

If I look in the build doc, there is no +9V connection at the lower end of the PCB: it's ground, LED switch ground, LED+, LED-, in and out. Makes sense as the switch does not need 9V  . The bottom ground pad is connected to the top ground pad (you can check with a DMM set for continuity). So, the top 9V+ goes to your testing rig, either of the grounds, and the in/out.

Ahh ok, thank you. I was even more confused than what I thought!

Thanks for setting me straight!