Who designed the sea flea?

[blearyeyes]

I had to cut between two traces that were shorted on one of beans production boards.
Somehow the 18v trace was touching the 9v input pad.
Took a lot of patience which is in short supply these days.

[jimilee]

Been did a production dress urchin? Does said modification apply here?

[blearyeyes]

No I was just sayin bad boards happen.

[jimilee]

No I was just sayin bad boards happen.

Oh yeah, it happens for sure.

[jimilee]

Do you think bad electros would cause this?

[alanp]

Just noticed a missing trace -- connect the south end of C22 (the non ground end) to the R12 pad directly below it. I feel so stupid. Don't know if this is your problem -- check continuity between those 2 pads first before you join 'em.

[muddyfox]

ok now i need to go check out my seaflea about this because two days ago it was working just fine.

[jimilee]

Just noticed a missing trace -- connect the south end of C22 (the non ground end) to the R12 pad directly below it. I feel so stupid. Don't know if this is your problem -- check continuity between those 2 pads first before you join 'em.

got continuity there, no worries. Where can I start the audio probe to see if it's even doing what it's supposed to before it goes to the delay pot?

[muddyfox]

ok now i need to go check out my seaflea about this because two days ago it was working just fine.

Ok, I have another unpopulated seaflea and c22 and r12 are connected, as are ones on my populated board.