Dead Ringer 2-in-one wiring?

[MIM#1]

Hey guys, I'm sure this is obvious but not to me  I'm working on the Deadringer V2 and would like to combine it in one box with a compressor circuit. But the way the jacks are wired to the board I'm not sure how its done. I've done several 2-in-ones the old way of just linking the switches but I'm not sure how to pull it off with this diagram.http://www.madbeanpedals.com/projects/Deadringer2/Deadringer2.pdf

[jkokura]

It depends on if you have the compressor before or after the DR2.

Before, you go from the output of the comps bypass switch to the input of the PCB. After you go from the output of the PCB to the input of the comps bypass switch.

Jacob

[MIM#1]

Thanks Jakob! 

[blearyeyes]

I'm sure you already know there are some little PCBs for order switching floating around so you could have a toggle and be able to switch.  Don't know if that would be worth it but might be cool...

[MIM#1]

Ok, still not too clear. The comp is before the Deadringer. So do I go into IN1 or IN2[boost] Also, I guess I need to cram 2 wires into IN1  or 2 cause a wire still needs to go to the Deadringer footswitch from there?

[jkokura]

The compressor's output from the bypass switch is put in the place of the input jack wire in the dead ringer. Wherever the input jack connects, that's where you connect the comp.

Jacob

[MIM#1]

ok, got it! Iwas thinking board input 1 or 2 :-/