Kingslayer... No switches... Do I solder a jumper??

[rydog2223]

Hey guys!  I'm opting not to do any switches with my Kingslayer.  Do I have to solder a jumper wire in the clip holes on the PCB board or leave them open?  Thanks so much guys!!!:)

[midwayfair]

Yes; without the jumpers, the diodes will never be connected to ground. Use your multimeter to check continuity to make sure you jumper the right pads.

[rydog2223]

Yes; without the jumpers, the diodes will never be connected to ground. Use your multimeter to check continuity to make sure you jumper the right pads.

Thanks man!  So there is no hard and fast rule about what pad to jumper? Thanks again!