Help wanted!

[DutchMF]

I want to give both breadboarding and perf/vero a try, to give the learning curve a boost upwards, and will be ordering from both Smallbear and Banzai in the near future, any advice on what to get? Thanks in advance!

Paul

[Om_Audio]

(parts for) Bazz Fuss? Thunderpuss? Something simple I would guess? I have yet to try my breadboard out, let us know how it goes! Also, with a really simple circuit you could try to do it from the schematic alone without a layout!

C

[Vallhagen]

On breadboarding.

I just grew out of my smaller "one-row" (or what you call it..) breadboard, and orderred this "three-rows", will be enough for a while i guess:
http://www.banzaimusic.com/Breadboard-EXB-2420.html

...so hint will be: Dont buy too small. Or maybe you allready had a board?

These - or similar - are essential:
http://www.banzaimusic.com/Jumpers-140-pieces.html

***

Then there are ways to setup a testrig with in-outs and a separate aluminium breakoutbox with 3pdt switch and all... i find that a bit overkill. I run my breadboard on battery, and have super-glued some plastic 6.3mm jacks direct to the boards bottomplate.

Cheers