Drilling bit sizes

[Resoamp]

  Just hold the part to be fitted next to the sharp end of the drill. Is it bigger or smaller? Do this till you find a drill that is slightly bigger than the part you intend to use. Or drill small then use a reamer! Are you sure you should be using a drill? This is not rocket science.

[Om_Audio]

Good morning Mr. Snarky McSnarkster. No need to reply to a thread if it bothers you. FYI I don't have regular bits that size and stepped bits are hard to do as you suggest. Plus I am spoiled on the fact that the people on these forums know just about everything.
Thanks for the suggestion!
C

[jkokura]

Easy gentlemen. Please be kind.

Jacob