Smallbear Pots

[masterlk]

Hey guys - The pots I got from Smallbear have a little tab on the right side which prevents it from laying flat in the enclosure. From all the build reports I've seen, I don't see that anyone is drilling a small hole to accommodate for this. Is everybody just clipping the tabs off? Thanks in advance.

For example Smallbear part number 1005A

[madbean]

Pliers and wire cutters will work for this (I never use those tabs). Just don't pull the pot shaft while doing it...you could mess the pot up (speaks from experience)!

[masterlk]

Ok, once again thanks!

[stecykmi]

i haven't been doing it so much lately, but if you've got the time, it may be worth drilling the extra holes. it makes your pots super-stable in the enclosure. just make sure your knobs are large enough that they'll cover the hole.