Adding a Volume Pot to the Sqweeker Circuit?

[marginwalker]

Hey everyone, I'm a total noob at DIY pedal building and was wondering how to go about adding a volume pot to the Sqweeker circuit? Also, what value pot should I use?

thanks!

[madbean]

Welcome to the forum!

Easy enough. Use a 100kA pot. Solder one wire to each lug of the pot. Lug3 gets wired to the OUT on the circuit board, Lug1 should be wired to ground (wherever is convenient, either on the PCB, or on one of the jacks or switch) and lug2 is the new output---that gets wired to the 3PDT switch where the original OUT would have gone.

That's all there is to it.

[marginwalker]

thanks very much madbean! i cannot wait to get all the parts in to get this going!