LT1054 in Sunking!?

[TheCobbenator]

Hey everybody. It's spring break and I've got to finish some PJs I started over Xmas.

Anyway. Can I use the LT1054 in the sunking? I'm thinking I could either cut the trace between pins 1 and 8? Or I read in another post that ibodog said to just bend pin 1 up so it doesn't connect.

I'm trying to get this PJ done without ordering anything new and I think this is the last hiccup.  Thanks gents!

[jkokura]

Just bend up pin 1 and you should be fine. Don't cut the trace though.

Jacob

[TheCobbenator]

Thanks Jacob! I can't wait to get this thing fired up. I'm putting in BAT41s and TLE2072s.  I'm pretty crunk about it!