Imp v2 help!

[redkurn]

So I built this pedal like 3 years or so ago, Brian has the sales record so he could confirm roughly when. 😂

Tested in a plastic container, worked great, boxed it and broke the tone pot. Too rough.

Fast forward to today, I replaced and confirmed the tone pot was bad, tested the new one, installed and it is stuck wide open.

So need to know the traces to track my issue down so I can finally put this one to bed. What else could be causing it to stay open?

I'm thinking a short, I was careful installing my input jack, it might be touching, doubtful, what else could be preventing the sweep?

Side note the forums don't like letting me reply on my phone or computer.

I keep getting a you already posted error. 🤷

[redkurn]

https://www.madbeanpedals.com/projects/_folders/1590A/pdf/The_IMP_v2.pdf

[redkurn]

don't be silly kids, remember to remove the bypass jumper that you installed 3 years ago. also mayb make a note on tape inside the enclosure lid about it. 

mistook it for a resistor or diode that i had to install wonky, new potentiometer fixed my tone pot issue.