Blueprint tap tempo

[Aentons]

Strange, took it out of the case and it works fine. Works fine back in the case now too. Oh well

[Aentons]

I've been looking at the Blueprint schematic.

I see that the X1 connectors are the row at the top of the board for connecting the tap tempo daughter board, and X2 is the 10k resistor network.

[fair.child]

For those who want to build Blueprint with tap tempo, here's the configuration:



I have spent days and night to figure about it. Peter helped me out with the wiring.

Here's the guideline:

1. Build the Blueprint, follow MBP Build Doc

2. Leave the JUMP open and jumper the TAP. I'd suggest to get 0 Ohm resistor and put it on the back in case you don't like it and wanted to switch to normal. For my Blueprint, I do socket those resistors so it's easier for me to debug. It's recommended but the PT2399 will be a tight fit. Watch out while you're soldering.

3. Get the Tap Tempo board from UK Electronics.

Kit Tap Tempo V2-TA for Digital Delay PT-80 *This is what I have
[130-095]
https://www.uk-electronic.de/onlineshop/product_info.php?products_id=3099

OR

Kit Tap Tempo V2for Digital Delay PT-80 *This is what VFE Blueprint has
[130-094]
https://www.uk-electronic.de/onlineshop/product_info.php?products_id=1797

4. Populate the Tap Tempo and wire the tap tempo board to Blueprint board. Follow the picture above.

5. Test it out and hopefully, it works!

[zgrav]

thanks for sharing that info.  I have built the Blueprint and may try this mod.