Endgame - TerminusV2

[Willybomb]

Terminus was playing up a bit and it turned out it was the source of noise I was getting in my pedalboard.  I decided to build something similar but better, and this is the result:

Klon buffer, into a splitter (one out goes directly to a 1/4 out for an amp), to a Bloviator, to Lart's Simple Cabsim, to another splitter that goes to the volumes for the 1/4 out and THC's Linedriver with XLR output.  Bit noisy, think it could be the splitters, but not bad.

[Andlord]

If it is noisy try isolating the modules. If they all are good try shielded wire.

Looks good as always!

[EBK]

Are those two boards stuck to the side just acting as a power bus?  I may have to adopt that idea for my own builds so I can stop trying to solder a half dozen wires to my power jacks.

[Willybomb]

Are those two boards stuck to the side just acting as a power bus?

Yep.  Normally I'll decouple them all too with a 100r resistor and a 100uf capacitor but couldn't be bothered in this case.  They'll normally all go to the same vero strip too, and I probably could have this time too, but ultimately I couldn't be bothered.

Have a look at Leviathan for an example of decoupling with all the power and ground going to one strip.