Naughty Fish issue

[U4U]

Hi,

I have some trouble with my new Naughty Fish pedal. If I switch the "Range" switch (Up/Down) to the right I get an annoying whistling sound and the second LED is always on and always bright shining. Otherwise it works if I set the switch to the left, but without the second LED light up at all. I need advice here. The second LED is a yellow one, but has the same voltage range as the red one I would use and I used for the bypass indicator. The on/on/on switch seem to have no significant value in left position. I can hear no change to the signal.

Thank you very much, U4U

[jimilee]

Led on all the time is usually indicative of a short somewhere, check all your solder joints first.


Sent from my iPhone using Tapatalk

[U4U]

Hi there, had it on hold for month because of less free time. The point is, using the range switch, the LED light on while selected right (down setting?) and no light was seen while select left setting (up). Setting it to the right a high annoying tone can be heard.

Thank you, U4U

[U4U]

...I'm searching this forum. Seems that it could be an issue because of the MACRON problem. I'm rather pissed, as I spend a few bucks on these

[fredwreck]

Yes I had a problem with those too... Get rid of them