Nameless Flanger

[Jules]

Alan's Nameless Flanger in a purple Hammond box as tribute to the Lovetone original.
I haven't applied decals yet, I was to keen to finish it!
I put the indicator LEDs in backwards but after I fixed that it works great, a lot of bizarre sounds in here!
Thanks Alan

[selfdestroyer]

Damn, that was quick. You got any gut shots you can share?

Cody

[Jules]

Yep, here you go

[BrianS]

I have to agree with Cody "that was quick."  Great job. I am on vacation and looking forward to getting home, putting this together and hopefully have a working pedal when done.

[alanp]

That was damn quick! Any problems, either mechanically (it's a tight squeeze), or electrically?

[Jules]

I am very pleased to say there were no problems.
I did measure all my bags of resistors to make sure there values was correct.
I didn't pay attention to the silkscreen and put mi indicator LEDs in the wrong way but easy fixed. It wasn't even as hard as I thought to setup with the trimpots, easier than the ADA.
There is a lot of off board wiring, but if you be careful with what you're doing it should turn out fine.
I used square green LEDs for the vactrols and coloured in the sides like Madbean does on the 1590g wigl vibe.
I was up very late last night finishing up.
Thanks

[stringsthings]

That was super quick.  Looks great, also.

Will the Tayda LDR's work for this build?

[alanp]

The datasheet for the Tayda LDR's say 500k dark resistance. You need 20Meg.

Depth would be pretty poor in all regards if you tried them, I suspect. I haven't tried Tayda LDR's in this build, myself.

[Jules]

I used the Small Bear 9203 type CDS photo cells, they are a bit tough to find 20k - 20meg.

[stringsthings]

Small Bear it is then.  Thanks for the info.

[LaceSensor]

i was scratching my head to remember where to source teh LDR from