Harbinger light not pulsing

[murdog47]

Rocked it before I boxed it and it was working fine. It is lit up and the intensity changes with the trim pot but it is staying lit and not pulsing. Haven't had a chance to run through troubleshooting yet. Anyone else run into this?

[brejna]

 I had similar problem with mine first univibe build and the problem was in R45 (in your case)... It was not gounded.. So you could check that.

[pryde]

Rocked it before I boxed it and it was working fine. It is lit up and the intensity changes with the trim pot but it is staying lit and not pulsing. Haven't had a chance to run through troubleshooting yet. Anyone else run into this?

Are any of the pots in a weird bind when tightening the nuts down? I am assuming they are pcb mounted? because of the dual-gang pot I had to add some spacers under the regular pcb mounted pots so everything would tighten flush to the enclosure.