What voltage capacitors for snack shack?

[EndlessOcean]

I'll get a pic up tomorrow. I sent the guy at Small Bear the pdf of the build from this site. He looked it over and said he would swap the Mallory 600v ones for some Panasonic ones as I was a bit unsure about using a 600v cap in this circuit and didn't want to fry anything.

As for ordering the right ones? Well, I ran the resistor values and they're all good. I followed the links given to me in this thread, but some were changed. I trust SB's knowledge in this far more than my own.

Anyway, pic tomorrow

[EndlessOcean]

well after a big delay I got the photos. I stuck them all together in one big photo, numbered them, and typed out the hard to read lettering on some of them. The 6th one was sent by Brian, so must be correct!




I think I'm almost there. And guys, thanks so much for your hand-holding, I really appreciate it.