Does anyone have the vertical dimension of a new Fasel inductor?

[midwayfair]

Trying to figure out if I can get one in a 1590B.

[DutchMF]

I found this on the Harmony central forum:

The one in my Cry Baby Classic (red) is:

1.5 cm diameter
2.0 cm long with the pins
1.25 cm high
1.25 cm pin spacing

Those should be pretty accurate, as long as you can convert them into your antiquated imperial system.

Just searched for 'Fasel inductor Dimensions' Don't know if it is correct, if you need help converting it to inches, let me know

Paul

[midwayfair]

Hmm, 1.25mm isn't terribly high. I guess if I needed pots I could use 9mm or side-mount them.

Smallbear sells these, I guess I can ask them, too.

[DutchMF]

Hmm, 1.25mm isn't terribly high. I guess if I needed pots I could use 9mm or side-mount them.

Smallbear sells these, I guess I can ask them, too.

Watch out, dimensions in centimeters!!!! 1 cm = 10mm, 1.25 cm is just a hair under half an inch! You're probably right, best bet is to contact SB and be really sure.

Paul

[midwayfair]

Hmm, 1.25cm isn't terribly high. I guess if I needed pots I could use 9mm or side-mount them.

Smallbear sells these, I guess I can ask them, too.

Watch out, dimensions in centimeters!!!! 1 cm = 10mm, 1.25 cm is just a hair under half an inch! You're probably right, best bet is to contact SB and be really sure.

Paul

Yeah, I know (it was a typo before). Most electrolytics are 11 mm tall, which gives me a pretty good idea of what I'm dealing with.

[midwayfair]

Wow, they're 19mm tall. Sheesh. My dream of using an Ernie ball VP for my wah pedal is getting increasingly remote,
.