Apologies if this has been addresses previously, but I can't seem to locate it on the forum.
I'm just getting around to building a Serendipity v. 4 from a single-sided etched board. If I'm reading the wiring diagram correctly, it looks like the DC power jack is wired for tip-positive. Is this correct? This also appears to be the opposite of the v. 5 diagram.
As an aside, I fear I may have fried a few components trying to figure this out
I'm relatively new to building, so I guess that's part of the process.
Thanks!
Justin
I'm just getting around to building a Serendipity v. 4 from a single-sided etched board. If I'm reading the wiring diagram correctly, it looks like the DC power jack is wired for tip-positive. Is this correct? This also appears to be the opposite of the v. 5 diagram.
As an aside, I fear I may have fried a few components trying to figure this out
I'm relatively new to building, so I guess that's part of the process.Thanks!
Justin