Messages

my deepest sympathies

Any interest in this pedal from any other people? Sounded like one of the best auto wahs i've heard. I  remember this being looked into at FSB and think they got a clone working.

What temp do most of you have your irons set to? I know this has a lot to do with what solder you use as well but what are some guidelines? I don't want to fry any of my expensive mojo components.

Funny you mention the ink thing. I was going to have some stamps made and try that. do you then use a clear coat?

I went with a 125B knowing i would probably screw something up and need the extra room

The Sprague Atoms I got are just a smidge too big to fit flush to the board. That's what I get for not measuring I guess.

After a few builds I'm struggling to see the advantages of pre-bonded wire anymore. What do you all prefer?

good to know. thanks. those footswitches are still a mystery to me. like women.

Nice clean, tight build.

Looking at the footswitch wiring though, should'nt 3A and 2a be connected? 

those look hot

With stuff like the BYOC Flanger already out there (which is really nice), the only thing I can think of that would be cool is something like the TZF Paradox that Foxrox used to make. There aren't any 'thru-zero' flangers out there anymore.

I vote for the DAM Sonic Titan. It's an interesting box considering it's a 'power amp distortion' pedal. It's not your usual fuzz or feedback clipper.

whoa! you rule

what version did you end up going with? Is it going to be the 4 knobber?

very un-boutique of you

What caps are you using there?

Thanks