Messages

HI mate,

Try the Power Pellet project that Chromesphere on these forum's came up with

It's for helping to reduce mains power hum, so it might be of assistance to you, plus it doesn't take up much real estate on the pedalboard

Here's the link for the Power Pellet:

http://www.madbeanpedals.com/forum/index.php?topic=3316.0

It's perfect for a beginner level DIY guy like me, so if you are experienced with electronics then it should be really easy. There's only 5 components

That said, sometimes it's the little things that make the difference

My Power Pellet project is currently underway, and I'm looking forward to it being a permanent fixture on my board

I am also looking for a noise gate pedal as well to complement this, I too stack O/Ds, and like you I want to reduce as much noise as possible without putting my guitar back in the case, and unplugging everything....

I have a Telecaster mod, with Single coil P/ups.

Do you also have a Telecaster??

Is your guitar "Shielded" ??

Hi Everyone!

Mark's my name! This site is great! I'm learning alot!

...really want to find THE PERFECT diy trem (using a boss TR2 at the moment and it's almost exactly what I want)...... a Matchless hotbox i'm building with a mate...

Hi Sir,

do you have a schematic for the Matchless hotbox clone and a diy guide link? if you do could you please PM me the link??

did you find a perfect diy trem??

Does anyone know where I could find the schematic and PCB layout for this pedal??

Is it under a different name in the forums??
I need one for sure.

Hi everyone,

I'm new to Vero board, I'm just wondering if I can cut a small section off without affecting the rest of the board, and is it safe to use a small saw blade to cut the vero? Can I use scissors? what is the better method?
I only want a small section. Will this have an effect on the rest of the board?