Hi. I'm new to the forum but I was wondering if I could get some help with my Yellow Shark build.
I've already tried to build honey bee clones twice on stripboard to no avail so this one is kind of my white whale so to speak. When I saw madbeans pcb layout I was ecstatic but even this one is giving me troubles.
Anyways, I have everything assembled but I am running into problems in the clipping section (drive pot). The rest of the pedal seems to work fine but the green clipping LEDs are lighting up and there is almost no distortion coming out of the drive knob. It basically acts like a clean boost, which would be fine if that's what I was going for.
So can anyone point me in the right direction? Any help would be appreciated.
Thanks.
I've already tried to build honey bee clones twice on stripboard to no avail so this one is kind of my white whale so to speak. When I saw madbeans pcb layout I was ecstatic but even this one is giving me troubles.
Anyways, I have everything assembled but I am running into problems in the clipping section (drive pot). The rest of the pedal seems to work fine but the green clipping LEDs are lighting up and there is almost no distortion coming out of the drive knob. It basically acts like a clean boost, which would be fine if that's what I was going for.
So can anyone point me in the right direction? Any help would be appreciated.
Thanks.