Messages

But it probably does depend on whether or not they need to do any setup.  I set everything up as an .AI file with an etching layer and a registration layer for quicker alignment on the laser bed.  If they have to dial it in for you, I suspect they will charge you for it.

Also, remember to outline the fonts in case the one you use isn't installed on their machine.  I also convert all artwork to vector to avoid pixelation, but that is not necessarily a hard and fast rule.

\


So glad this all makes sense to me....great to be a graphic designer..

Ok, great job. Gotta know, where does one come across a lazer engraver??

Sounds pretty rad. Thanks!
w

Cool Ginga! For sure one I built.

Looks like I will be building one of these compressors for the Bass player in my band...cool.

Thanks gents. I mainly put it there because I used a huge 330µf cap...had I know that the cool kids put them over the pots I would have....

SAHWEET!

Hell yes! Did you have fun binding? what kind of glue/technique did you use?
Great job.

Thanks guys. Not as clean inside as the last, but it seems to work fine...

Hey all,
Here is my second successful build. A GGG Red Llama board, BYOC enclosure. I tried building this on perfboard but it didnt work so I went ahead and bought the PCB...so much easier!

I drilled the enclosure and did the paint and graphics also using inkjet decal paper. The pics don't do the color of the paint justice. It is a nice red, red....

The owner of the local R.S. is one of the last real dudes....he helped me tons with components and has been a great resource..Thanks Bill!!

I didn't have the right ceramic caps so I used a 68 and 151 instead of the 51 and 101 that are recommended.  
From what I understand this rolls off some of the highs, which is fine cause I am playing my electric mandolin through it and it tends to be bright anyways.

Sounds pretty damn good too! Although there is some added noise when I turn up the volume.






Done a Ross/Keeley clone and this....What should be next? Delay? Wah? I need both. Oh wait....a pedalboard....

i couldn't even get close....

I had a Korean girlfriend once who was "very, very sensitive to the touch".....Wasn't able to mod that...

You don't want to see the circuit.....

Thanks fellas....will work on that after dinner...
Jason

Thanks...duh. Is that the top of the pot in your pic? or the back?.....top, ok but then

"lug 2 is the output of the circuit"....which one goes to the output jack? The middle one, right?


The pot goes between the circuit and the output jack? That pic isnt showing wires, just the relationship of the lugs to the schematic, right?

How does the switch relate to this? I need images.