Messages

I am working on building the Wolfbagger sample rate reducer seen here:

https://sites.google.com/site/electroconducive/wolfbagger-aliaserproject

And one of the mods to make the width pot more usable was posted as

"Note that R20 was changed to a 100kb freq pot with 1k in series and the freq pot was replaced with an 82k per mod guidelines. He also noted that fooling with c12 will alter frequency. "

I am note sure how to go about wiring it this way and would appreciate a little help.  I am guessing that the 82K resistor just goes on the board between holes 3 and 2 intended for the freq pot.  But how do I wire a 100kb pot with a 1m resistor in series at r20?

Thank you,

Are you getting any oscillation bleed through on yours?  I built one based on the vero, sounds great, but even when bypassed it was getting bleed through to the audio. Ended up having to short the 40601 when bypassed.

If I am using the road rage to get =9 and - 9 voltage for a bugcrusher build, do I need the 7815T voltage regulator?

Thanks