thx
- Welcome to madbeanpedals::forum.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#3
Open Discussion / Klon help
March 05, 2013, 05:47:50 PM
Hi there!
I need advice with my klon Project, im with the etching versión, but following the diagram i soldered the c6 cap, and in the layout i see a jumper ¿?=¿ between r 8 and r9 ¿?
So what i should do?? leave the cap there or remove and jump it?
any help wellcomed!!
I need advice with my klon Project, im with the etching versión, but following the diagram i soldered the c6 cap, and in the layout i see a jumper ¿?=¿ between r 8 and r9 ¿?
So what i should do?? leave the cap there or remove and jump it?
any help wellcomed!!
Pages1