Messages

Another truckload of Schutone brilliance! Excellent to the hilt.

When I was in the States four years ago I of course bought a ton of stuff from Smallbear and TubesandMore to bring over to NZ, in fact half of my suitcase was full with ICs, tubes, pcbs and wire and all. It was no problem to have in the suitcase (I didn't have it in onboard luggage) and it went through domestic and international flights and customs, no problems.
However, every time I picked up my suitcase I had a note inside that they checked the content and opened the suitcase, it must have looked somewhat... well... unusual... to them. Undies, socks, T-shirts and wire and tubes.

Awesomesauce! 

Spot on tight build, great work!

Excellent, certainly a lot of fiddly stuff to get this going! Lots of tweakability there in spades.
Great looks to boot, very nice!
I think the Hydra is a super delay, dig it.

Just as cool as generous, very nice builds and prezzies!

Bang on! Very nice build and loco!

Sweetness and top graphics too! Is that Tayda UV print?

Great build and the zebra looks are a happy accident indeed here. Fab.

Spot on, nice builds!

Out if sight tidy and cool looking build, great stuff!

Great video! And bang the FV-1 is on, no sweat.
The only thing I do differently is adding liberally liquid flux with flux pen and clean off after that with alcohol.

Thank you! With adding the flux and using the alcohol does it leave any residue behind or stickiness?

Not with the one I use, the flux is pretty thin and watery, so easy to clean off.

Great video! And bang the FV-1 is on, no sweat.
The only thing I do differently is adding liberally liquid flux with flux pen and clean off after that with alcohol.

Rad! Great build, fab etch.

Lemme get my microscope, I can't see it without....
Crazy good, you need to put a matchbox beside it to remind us of size of the enclosure.