I'm upping this because I've built a Bassdrive following Harald Sabro's layout, which is based on madbean's Deadringer schematic.
There's something weird with the FCV switch...
Referring to this schematic (and assuming that I get it right...), diode clipping is engaged when B1 and B2 are shorted (pins 4 & 5, right?). My on-on-on switch is the same pinout as the one linked in the manual (Smallbear item 900), thus diode clipping is only engaged for one of the 3 modes...
Moreover, the "flat mid" mode (ie R13 & C9 are in the circuit) is on only when diode clipping is not engaged...
I can take care of the modifications myself but thought I should point it...
There's something weird with the FCV switch...
Referring to this schematic (and assuming that I get it right...), diode clipping is engaged when B1 and B2 are shorted (pins 4 & 5, right?). My on-on-on switch is the same pinout as the one linked in the manual (Smallbear item 900), thus diode clipping is only engaged for one of the 3 modes...
Moreover, the "flat mid" mode (ie R13 & C9 are in the circuit) is on only when diode clipping is not engaged...
I can take care of the modifications myself but thought I should point it...