Messages

Yes Jebus.

Input fx grounded.

Tube amp?


Sent from my iPhone using Tapatalk

Yes, Vox AC15 or Fender Champ DIY

Power Station with 7809cv

I add a buffer before pedals chain

Which circuit pops? What circuits are in the box?


Sent from my iPhone using Tapatalk

All circuit pop.

Guitar -->CrunchBox-->TS808-->Klon-->SanSamp-->Rub a Dub Reverb-->Amp

Hi guys, first of all sorry for me English.

I'm having some trouble with switch pop. I have put 5 pedals in one box. Led's don't cause "pop" in this case.

I use this wiring. In grounded (not show on picture) First 3pdt jack out goes to In jack from the next 3pdt.



What do you think? Can you help me?

Hi guys, I'm looking for Xotic Sp compressor and I can't belive no one made a clone of this...I searched in this forum and on web and nothing...

Schematic?pcb? nothing?

Well resistor 150k goes back to 47k and I change 33k from pin 2 of IC to 24k. Then i upgrade 33k from IC out to 47k.

(sorry for me english)

Well to start your input gain is below unity, which wont help, increase the 33k in the feedback loop of IC1B to 47k.

You can drop the 11k resistor value off the repeats pot too.

Yes, i increased resistor (33k to 47k) and like in the first photo i increased 47k to 150k, put it back to 47k?

Does anyone can help me?

Guys! I built this delay pedal. Basicaly it's a rebote delay with some values changed.

I made some modification to make it more useful but i still have problems with repetition volume. So, can you help me with this?

Check classifieds. I have a fabbed Ecstasy board for sale. (Vipfx product)

Thanks Pryde but i'm from Argentina so I can't buy it. I want an etching pcb

Hi guys, has someone a pdf with PBC and layout with Wampler Ecstasy? i only found veroboard and i don't understand it.

Pics



Schematic

Thanks brejna but this pdf have the boost part and i don' t want to.

Hi guys, I'm looking on web a pcb to build Lovepedal OD11 and not appear. Searching I found that is very similar to Paul C Timmy overdrive, some value change, the big difference are extra diodes and dip switch on Timmy.
I found a pcb for timmy, so if I remove extra diodes, dip switch and change some value it work fine?

I tryied to make a pcb on eagle but i have lots of problems.

Image to compare

OD11



Paul C Timmy

Hi! Do you have this proyect with etching pcb?i'm looking on web but it not appear

The cap value changes should not cause any oscillation, but possibly the resistor value change did. Put it back up to 15k to see if that eliminates the problem. Instead, increase C7 from 82n to 330n.

Thanks for answer. Yes, I change again the resistor and it's the same.

C7 is for clean dirt? i will try this to increase bass.