Quote from: madbean on December 22, 2010, 05:35:29 PM
There's not a lot of gain in this design, but since it's active pretty much the whole way through, there should not be much signal loss, ether. How much of a drop do you have between bypass and effected signal?
You can balance this out a bit more by increasing R17. 100k will probably be okay there. Maybe socket it and try a couple of values above and below that, too.
OK, i tried and the least volume drop i get with a jumper instead of any resistor. I would say about 30%, before it was about 70%.
I play through a Creative Laptop Speaker System instead of a guitar amp, could that be the reason ?