Which way do you orient the LEDs?
Negative leg to the square pad on the PCB or positive leg to the square pad?
Negative leg to the square pad on the PCB or positive leg to the square pad?
- Welcome to madbeanpedals::forum.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
General Questions / Re: How to power two effects in one enclosure?
April 08, 2012, 09:48:06 PM
Should I also run a ground wire from each PCB to the ground lug on the DC plug?
#3
General Questions / How to power two effects in one enclosure?
April 08, 2012, 02:18:49 PM
Hello all , new to forum. I apologize if it's been covered in previous thread.
I'm building a TS808 clone and a EH LPB1 clone and want to put both circuits in one enclosure.
Will one DC plug/one 9V battery snap be sufficient to run both circuits?
Thanks
I'm building a TS808 clone and a EH LPB1 clone and want to put both circuits in one enclosure.
Will one DC plug/one 9V battery snap be sufficient to run both circuits?
Thanks
Pages1