Messages

when I engage the pedal and cut the volume full up then my output is the same loudnes as the bypass.. I think that's because the drive would normally add more volume when working with the vol knob.  The pots are wired in the right spots.  When I was soldering I know on a few of the spots that ground to the board, my solder was kinda large.  But that's what it's grounding to so I didn't think that would be a problem.

yes the tone and drive do absolutely nothing.  they don't affect the volume at all.  right now i'm checking all the tracks and my solder points.  I'm going to clean the PCB too.

Thanks!

Hi, I built the Neutrino and when I turn the pedal on the only pot that seems to work is the volume pot.  I can turn the pedal on and my clean signal goes through it while i can adjust the volume.  But when I turn the tone knob or drive knob nothing happens and there is not effect. 

Can someone help me fix this?

Thanks.