Messages

Hey man, just wanted to say I've watched a lot of your videos on YouTube and they've been super helpful. I was looking into Tayda as I came across your video then decided to order after seeing it. Thanks for putting all that work into making your videos, it's really helped a lot!

I think I'm gonna go with the LoFoMoFo, looks pretty easy to lay out on perfboard. Thanks for pointing me in the right direction!

Hello all! I am looking for a DIY pedal that has low cut and high cut, similar to the Ibanez LF7 here: http://www.youtube.com/watch?v=a-eLTP3Zdtc

I am guessing all I would really need is some kind of EQ pedal that can make steep cuts, but I haven't really found a good project out there for it. Seems like this would be a pretty simple circuit to make, but I'm very much a newb so far.

Ordered an Afterlife and can't wait for it to ship!!

Just leave the battery snap unconnected at both connections. Thats it! easy hey?

Now for the stomp switch. I use a leftover resistor lead that has been snipped to connect those three ground points but you can most certainly use a a bare wire. In fact, thats how I started doing it.

Brilliant idea on the switch, wish I would have saved my clipped leads!

If I want to omit the battery snap and just use the D/C adapter, do I just run a wire from the input ring to the dc jack or do I just forget the wires between the snap and the swith/dc jack?

Also, for the 3PDT footswitch, there are three different places you connect the ground. For the actual wiring, is it best to just run small jumper wires between the three connections? I haven't been able to find any up close pictures of what it's supposed to actually look like.

Thanks!!