Messages

 Hi !  I dont know how to say thankyou!

Finally I check R5 and you right it´s 470K in my pedal!  ???Yes I´m wrong ...I don´t know how not I see it before...

I change it (now is the only recicled part of the circuit , it comes from an VHS Sharp Video recorder .)  and it works perfect !

I feel good but stupid at same time, cause I was checking it during a week...I was obssessed with the caps and the ic´s,don´t ask me why!

Well now I readed the how to have help tech in the forum...and the next time I rest during some days before to check and post.

This is not my first pedal but ussually I debug all without no more than three days, at this time I feel so stupid because I read a lot of times the formu but never before need to say Heeeelp!

Thanks to everybody for the support !

When I got it finish I link some pictures and audio demos ,but everybody knows madbean sounds awesome ! 

And sorry my english !

Yes ,I´m spanish ,my english is poor sorry! But I try ...

Thank s to all for the answers! The links are awesome thanks jacob!

I re-check the resistors tomorrow, I tested today the pedal with a guitar with P90 pickups,it sound but have no saturation , the tone control works the volume and the booster control works , the gain and the crunch controls don´t response , The pots are the values recomended for madbean, all the stuff is brand new no recicled parts , when I checked all the resistors I try to mesure the values of the ics pins and report to this forum ,Thanks again to everybody !

Hello I'm riding the Boneyard, so far does not sound effect, only boster does ,

not know if my list of components is correct for the values ​​of the caps, because I thought it worked in 9 vol did not think the ic 7660 when purchasing components, and checked all the welds,

and seen a post with the values ​​of voltages of the ic, where I put the ground tester to measure ic s?

My values ​​for the measure you ics are different tan the forum post, my ic is LF347N and S 7660.
Here are the values ​​writed on my caps:
 C1; 331
 C2; 22J63
 C3 Wima .033 250 -
 C4, 331
 C5 2.2 uF 50V
 C6, 47J63
 C7-; 68nJ100
 C8 47J63
 C9 151
 C10, 100uF 25V
 C11, 10uF 63V
 C12, 10uF 63V.
 All resistors are of the value of the project. In the picture is a tantalum cap same value for c12 ( just for test ) and leds are yellow for test too I tried de red ones but dont work ...
I hope your help thank you very much!

http://i1061.photobucket.com/albums/t478/Fulltester/CIMG1937.jpg