Messages

Thanks Brian, i checked all the wiring,  I had a bad resistor at R7, works great!

not sure if I should start  a new thread for this but... The cave dweller is sick! Sounds so warm. It replaces my Flashback... But the echo pot doesn't seem to do anything? Or is it really subtle? Is this normal?

Thanks again...

Thanks Jacob for clarifying! Just finished it.

Hi guys,

I'm working on the Cave Dweller 1 (almost done!) and it has 2 grounds? Do I use one ground for the power and another ground for the output? Can anyone tell me how to wire that up? I'm using the Madbean wiring diagram, bypassing the battery and using both mono plugs.

Thanks!

I redid/cleaned up the wiring on the switch and I also tried using a switch that I know works my sho, still nothing. So I'm going to redo the whole project - the soldering job looks really bad, I'm practicing hard here.

I'll let you guys know how it comes out - thanks!

Hi guys,

I just finished building a fatpants and I'm having an issue with it not working.

I'm following the "Standard wire diagram for MadBeanpedals projects" for the 3pdt and I am using a mono jack for the input and skipping the battery. I was testing it and getting a humm so I figure its the ground and I start desoldering the ground. Soon as I take the ground of the switch the LED light comes on. Still hums too.

Can anyone help me with this?

Thanks so much!

thanks for clearing that up for me mgwhit!

Hi again,

I did a search for this and I couldn't find anything which means... I'm the only one here that doesn't get it 

On the Firebomb project documentation, why does the Layout diagram (page 2) on look so different than the pcb on page 6? It has less parts and the year is different as well. I'm a little confused and not sure how to proceed 

Any help would be supercalifragislisticexpealidocious!

Thanks!
Mike

I think you can google "capacitor conversion chart" and you can translate the caps to the names you can find on mouser or tayda. The chart will show 100n Is equal to 0.1uf, etc...

Thanks guys - this is an amazing site, loving this place!

Hi guys,

I'm trying to find parts for this pedal and it calls for on REG1 an LM78L05. I ordered from tayda a L78L05. I was wondering if anyone can tell me if this is the right part or do I need to get the "LM..." and where can I find the LM?

Thanks!